Eurotech Appliances Winner - Manual (Page 5)

: Packing list
When you receive your WINNER device please inspect the package to verify that you have
the following:
1 . One WINNER GSM single/ dual channel gateway unit
2 . Adapter
3 . Antenna
4 . RJ-11 cable
5 . User's manual
6 . Guarantee
: Safety Guidelines
For the safe and efficient operation of your WINNER gateway unit, please observe the
following guidelines:
Please read the installation instructions and safety guidelines in this user's
manual carefully before installing the unit
Do not handle the equipment before disconnecting it from the electrical outlet
Do not use any cleaning agents or detergents on the exterior or interior surfaces.
If you intend to clean the device, disconnect from electrical outlet and use only a
damp cloth
Do not position device in a damp place; do not expose to water
Do not expose to extreme temperatures: optimal operating temperatures
-5° C to + 50°C.
Position equipment in a stable environment; any sudden fall or sharp movement
may damage the device
Do not cover or stick any foreign objects in devices' openings or ventilation holes
Do not operate your WINNER device while any person is within 0.02m of the
antenna. A person or object within 0.02 m of the antenna could impair call quality
and may cause the phone to operate at a higher power level than necessary.
Warning: Potentially Explosive Atmospheres:
Do not operate your WINNER near blasting caps, or in a blasting area, to avoid the
possibility of triggering an explosion
Do not operate a WINNER transmitter in a hazardous atmosphere: an explosion or
fire may result
The telephone interface is not designed for outdoor application:
RJ-11 cable must not be run to an outdoor telephone; this minimizes equipment
exposure to coupling and directs lightning surges.
General user information:
Placement of the device: the WINNER GSM gateway unit is designed for installation on
a vertical surface but may be mounted also on a wall.
If you wish to mount the device on a wall follow these steps:
1. Remove the black metallic strip used for hanging the unit on the wall by sliding it out
from the back of the WINNER unit
2. Place the metallic strip on the wall to indicate the location of the screws
3. Hold the strip on the wall and drill wholes for the screws to go into the wall through
the metallic strip
4. Place the unit onto the wall by sliding the metallic strip back into its place.