Eclipse - Fujitsu Ten CD5100 - Manual (Page 5)

- 5 -
Español
Français
Italiano
Nederlands
Svenska
English
1
3
4
5
9
16P
D
6
7
8
F
E C
B
ANTENNA PLUG
MAIN UNIT 1
INTERCONNECTING WIRES
(Power and speaker connector)
2
A
• • Never cut the insulation on the power wire or use it to power any other equipment. If the rated current
capacity of the power wire is exceeded, fire and electric shocks may result.
• • The wires should be secured with tape or a similar securing method to prevent any obstructions while
driving. If they get wound or entangled around components such as the steering wheel, shifting lever,
or brake pedal, accidents may result.
• • If removing the end of the wire to connect to another wire, be sure to wrap PVC tape or a similar wire
insulating method around the connection to insulate it. If the connection is not insulated, fire or
accidents may result.
• • Refer to page 6 for details on the wire colors and connection points for Interconnecting wires .
• • Refer to pages 6 to 7 for details on connection points to for the main unit wires and
terminals.
2
Tip
A G
Name and functions of ter Name and functions of ter minals minals
• • Use supplied wire harness with this main unit. Other manufacturers may use a similar wire harness
connector but pin configurations are incorrect for use with Eclipse main units and can damage the main
unit. Prior to powering up the main unit, please make sure the main unit is properly grounded with the
vehicle chassis. If no ground is available to the chassis, add a ground strap from the main unit to the
vehicle chassis to improve the ground.
• • Do not use with speakers having 1 to 3 ohms impedance. This main unit is designed to be used with
high-powered speakers rated above 50w with impedance rating between 4 and 8 ohms.
2
G
Tip*1
The CD3100 is not equipped
with connection terminals
, and .
Tip*1
F G D