Fulgor Milano 30 Inch Over-the-Range Microwave Oven Installation Guide - Manual (Page 7)

EN
7
Installation Guide
STEP 4
• Place the blower unit into the opening.
• Secure the Blower Motor Cover to the microwave oven
with the screw (1, 2 and 3) from step 1 and 2. See Figure
15.
Figure 15
• Remove the screw (4) for the Blower Motor Cover and
save screws. Remove the Cover Motor Hole from Blower
Motor Cover. See Figure 16-1.
4
Cover Motor Hole
Figure 16-1
• Carefully match the exhaust opening location of the
microwave and attach the damper to blower motor cover
by sliding it into the guides at the blower motor cover.
See Figure 16-2, 17.
Damper
3
2
Figure 16-2
Figure 17
Be sure that the damper hinge is on the front and the
damper swings free into the wall outlet.
8. Oven Installation
THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT
REFERRING TO THE MOUNTING INSTRUCTIONS FOUND
ON BOTH TEMPLATES.
READ AND FOLLOW MOUNTING INFORMATION ON
BOTH TOP CABINET AND WALL TEMPLATES.
Mounting Plate
STEP 1 - SETUP POSITION
• Draw a line down the middle of the studs (see Wall
Construction, page 3).
• Draw a vertical line on the wall at the center of the 30”
wide space. See Figure 18.
NOTE: Use the wall template for the rear wall. Reference
Wall Template prior to proceeding. Installation of this
product requires 2 people.
A
C
C B C
C
Power Supply Cord Hole
House Duct
Mounting Plate
Figure 18
1.TINSKB287MRR0_FULGOR OTR_F4OTR30S1_Install.indd 7 6/28/19 2:10 PM