Fulgor Milano 30 Inch Over-the-Range Microwave Oven Installation Guide - Manual (Page 6)

EN
6
Installation Guide
• Use side cutters or tin snips to cut and remove parts B
from back plate. Be careful not to distort the plate. See
Figure 10.
Parts B
Figure 10
STEP 4
• Place the blower unit into the opening and secure it to
the oven with the screws (3) from step 2. See Figure 11.
Figure 11
• Carefully match the exhaust opening location of the
microwave and attach the damper to the rear plate by
sliding it into the guides at the rear plate. See Figures
12,13.
Damper
Figure 12
Figure 13
Be sure that the damper hinge is on the top and the damper
swings free into the wall outlet.
C. Vertical Ventilation System
The unit is shipped assembled for recirculating.
STEPS 1 & 2
• A-1 Ventilation motor. See Figure 8.
STEP 3
• Turn the blower unit so that the fan blade openings are
facing upward. See Figure 14.
Fan Blade Openings Facing Up
After Turning
Back of Oven
Figure 14
1.TINSKB287MRR0_FULGOR OTR_F4OTR30S1_Install.indd 6 6/28/19 2:10 PM