GE Profile Advantium Series 30 Inch Over-the-Range Microwave Oven Owner Manual - Manual (Page 30)

30
49-7000135 Rev. 0
Care and Cleaning
CARE AND CLEANING
Halogen lamp cover and mica sheet
Do not remove the halogen lamp glass cover or the mica
sheet.
The upper halogen lamp cover must be kept free
of grease and food spatterings in order to operate
effectively.
Clean the lamp glass cover and mica sheet often to
avoid excess smoking and decreased cooking power.
To clean the upper lamp cover: Allow the oven and
glass cover to cool completely. Wipe clean with a warm
soapy cloth or plastic scrubbie.
)RUKHDY\EXUQHGRQVRLODFOHDQLQJVFUDSHUPD\EH
used to clean the halogen lamp cover. Hold the cleaning
scraper at a 30° angle. Scrape the glass clean and wipe
up excess soil.
To clean the mica sheet: Allow the oven to cool
completely. Wipe clean with a warm soapy cloth.
Outside of the Oven
We recommend against using cleaners with ammonia
or alcohol, as they can damage the appearance of
the oven. If you choose to use a common household
cleaner, first apply the cleaner directly to a clean cloth,
then wipe the soiled area.
Case
Clean the outside of the microwave with a sudsy cloth.
Rinse and then dry. Wipe the window clean with a damp
cloth.
Control Panel
Wipe with a damp cloth. Dry thoroughly. Do not use
cleaning sprays, large amounts of soap and water,
abrasives or sharp objects on the panel - they can
damage it. Some paper towels can also scratch the
control panel.
Stainless Steel Surfaces (on some models)
The stainless steel panel can be cleaned with Stainless
Steel Magic or a similar product using a clean, soft
cloth. Apply stainless cleaner carefully, avoiding the
surrounding plastic or glass parts. Do not use appliance
wax, polish, bleach or products containing chlorine on
stainless steel.
Plastic Color Panels (on some models)
Use a clean, soft, lightly dampened cloth, then dry
thoroughly.
Door Seal
It’s important to keep the area clean where the door
seals against the oven. Use only mild, non-abrasive
detergents applied with a clean sponge or soft cloth.
Rinse well.
Bottom
Clean off the grease and dust on the bottom often. Use a
solution of warm water and detergent.
Replacing the Surface Light
1. To replace the surface light, first disconnect the power
at the main fuse or circuit breaker panel or unplug the
oven.
2. Remove the screw from the side of the light
compartment cover and lower the cover until it stops.
3. Be sure the bulb to be replaced is cool before
removing. Gently pull the bulb from the receptacle.
Replace with a 130 volt, 50-watt halogen bulb. Order
WB08X10051 from your GE Appliances supplier.
4. Raise the light cover and replace the screw. Connect
electrical power to the oven.
)RUKHDY\RUEXUQHGRQVRLO
Upper halogen
lamp cover
Mica Sheet
Remove screw