Summit 1.2 cu. ft. Built-In Drawer Microwave Installation Guide - Manual (Page 13)

13
Anti-Tip Block
Figure 3
NORMAL INSTALLATION STEPS
ANTI-TIP BLOCK INSTALLATION
INSTRUCTIONS
To reduce the risk of tipping the
drawer, the Anti-Tip block must be
properly installed and located 13-16
inches above the floor on which the
Microwave Drawer will sit. The 6-inch
Anti-Tip block must be provided by the
installer. See Figures 1 and 3. The
Anti-Tip block prevents serious injury
that might result from spilled hot
liquids.
If the Microwave Drawer is ever moved
to a different location, the Anti-Tip
block must also be moved and
installed, when installed on the wall
make sure that the screws completely
penetrate the drywall and are secured
in wood or metal so that the block is
stable. When fastening, be sure that
the screws do not penetrate electrical
wiring or plumbing.
Electrical Outlet
Figure 4
The electrical requirements are a 120-
volt, 60Hz, AC only,15 amp. or more
protected electrical supply. It is
recommended that a separate circuit
serving only this appliance be
provided.
The drawer is equipped with a 3-prong
grounding plug, it must be plugged into
a wall receptacle that is professionally
installed and grounded. Should you
only have a 2-prong outlet, and have a
qualified electrician install a correct
wall receptacle.
Note: If you have any questions about
the grounding or electrical
Instructions, consult a qualified
electrician or service person.
*Can also be installed using an
electrical outlet in an adjacent cabinet
within the area where the provided
electrical cord can reach.
Always check electrical codes for
requirements.