Epson 80211b - Manual (Page 41)

37
Setting Up Additional Macintosh
Computers
Once the print server is configured on your wireless network, you can install
the driver and select the printer on each Macintosh. Then make sure all your
computers are set up for your wireless network.
1. Make sure you have installed the printer driver and utility software. See
the Start Here sheet that came with your printer for instructions.
2. Select your printer and network printer port in the Chooser.
3. Make sure your Macintosh is set up to use your wireless network,
following the instructions in one of the sections below.
If Your Macintosh Has an AirPort Wireless
Adapter
■ Make sure AirPort is enabled in the AppleTalk Control Panel. If your
Macintosh and AirPort Base Station or access point are connected over an
existing Ethernet network, select
Ethernet in the AppleTalk Control
Panel.
■ Make sure that both AppleTalk and TCP/IP are enabled in your AirPort
utility.
■ To use the printer in infrastructure mode, select a working connection to
a base station or access point from the AirPort Networks list.
■ To use the printer in computer-to-computer (ad hoc) mode, create or
join a computer-to-computer network. See your AirPort documentation
for details.
EPSON recommends that you use the print server with an
AirPort Base Station or access point. With AirPort, your print
server works more reliably in infrastructure mode than computer-
to-computer (ad hoc) mode.
ZLUHOHVVVHUYHUERRN 3DJH )ULGD\ 0D\ 30