Epson 80211b - Manual (Page 20)

16
Configuring the Print Server
After the software is installed, you’re ready to establish a connection to the
print server and configure it for your wireless network.
1. When you see the Wireless Server Search window, click START.
WP-Admin picks up the signal from the print server and displays server
information like the following:
If WP-Admin fails to pick up a signal from the print server, try
holding down the print server’s test button for at least five
seconds to reset it. The lights go out, then both the green and
yellow lights come on briefly. The yellow light remains on
when your network has a connection to the print server.
If it still fails to pick up a signal, check the solutions beginning
on page 40.
2. If WP-Admin picks up a signal from more than one server, select the
connection that matches the MAC address on the back of your print
server.
3. Check the signal strength to make sure you have a good link to the print
server. If you have a link, click STOP . Then click CONFIGURE .
Click START
This information
appears when the
server is found This number
indicates the
signal strength
ZLUHOHVVVHUYHUERRN 3DJH )ULGD\ 0D\ 30