Eiki EIP-25 - Manual (Page 10)

9
5.2Function list of remote control panel:
Function key Function description
Freeze/Esc/L
• OSD inactive: press this button to freeze the display image.
Press again to resume motion.
• OSD active: press this button to exit.
• Mouse active: Use as the left mouse button.
Enter/R
• During common status or using OSD options, please refer to
“Auto/Enter” of “Projector panel” in page 5.
• Mouse active: Use as the right mouse button.
Power
• Please refer to “Turning on and turning off the projector”
section in page 13.
Mode
• Press ”Mode” button to make LED light become green. At
this time, the remote control presents mouse status and
capable of simulating mouse.
• If no action is input within 15 sec, remote control will return
to common status automatically. Please press “Mode” button
again to return to mouse mode.
• You must have USB cable connected between your computer
and the projector to use this option.
Menu
• Please refer to “Menu” of “Projector panel” in page 5.
Source
• Select the signal of Analog RGB, Analog Y Pb Pr, Digital
RGB, Composite Video, S-Video and Component Video in
proper order.
Blank
• Press to set the current image into a plain blue screen. Press
again to restore the display image.
Auto
• This button can automatically adjust the picture position and
frequency.
Pg.Up
• Use as display image magnifying (*).
• Mouse active: Use as Page up cursor.
Pg.Dn
• Use as display image minifying (*).
• Mouse active: Use as Page down cursor.