Euphonix MC Mix - Manual (Page 8)

professional control surfaces
Artist Series
EuCon APPLICATION SETUP GUIDE
NUENDO
8
3.1.1 EuConized channel types
The EuConized channel types section contains checkboxes that determine
which channel types appear on your control surface. If a certain channel is
available in Nuendo and the corresponding checkbox is selected, that channel
can be selected to appear on the surface. This channel is called EuConized.
All channels except Input channels are EuConized by default and can appear on
the surface. This is useful to eliminate tracks from the surface, reduce memory
usage, and reduce the time needed to build the EuCon mixer model when con-
necting, adding, or removing tracks from the Nuendo project.
To enable/disable EuConized tracks, select the checkbox next to each type.
Tracks without a checkmark do not appear on the surface. This setting applies
only to the open project.
3.1.2 Global Settings
The Global Settings section has two parameters: Tape machine style transport
and
Number of knobsets to cache.
Tape machine style transport
Two Nuendo transport control modes are available for the control surface.
Toggle the modes from the
Tape machine style transport option.
These transport modes affect the operation of the Stop, Fast Forward and Rewind
buttons in the following manner:
Tape machine style transport checked
Stop: The control surface STOP button halts the transport and keeps the play
head at the current position (even multiple presses), independent from Nu-
endo’s preferences.
Fast Forward/Rewind: The FF/RW buttons always latch independent of the
control surface latch time preference. Repeatedly pressing the same
FF/RW
button has no effect. The current action can be stopped by pressing the op-
posite wind button,
STOP, or PLAY. The FF/RW also stops if it reaches the be-
ginning or end of the project.