beautypg.com

Fcc information – Emerson Radio CKS3088 User Manual

Page 4

background image

3

I M P O R TAN T N O T E S

• Operate controls and switches as

described in the manual.

• Before turning on the power, make

certain that the power cord is properly

installed.

• When moving the set, be sure to first

disconnect the AC power cord.

• Avoid installing this unit in places

exposed to direct sunlight or close to

heat radiating appliances such as

electric heaters, on top of other stereo

equipment that radiates too much

heat, places lacking ventilation or dusty

areas, places subject to constant

vibration and/or humid or moist areas.

FCC Information

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference

that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

CKS3088_072106.p65

21/7/2006, 15:04

3