Emerson Radio CKS3088 - Manual (Page 20)

1 9
Display Brightness Control
This SmartSet ® Clock Radio features a unique display brightness control system
that gives you three convenient options:
• HIGH – when the DIMMER switch is set to the “HIGH” position the clock display
is always at full brightness. The DIMMER switch was set to the “HIGH” position
at our factory.
• LOW – when the DIMMER switch is set to the “LOW” position the display
brightness is reduced by approximately 50%.
• OFF/WAVE– when the DIMMER switch is set to the “OFF/WAVE” position the
display goes ‘Off’ completely. This is designed for people who prefer to sleep
in total darkness. However if you want to see the clock display at any time,
slowly wave your hand in front of the WAVE SENSOR on the front panel. The
clock display will immediately return to full brightness for 10 seconds and then
shut off again automatically. The effective operating range of the Wave Sensor
is approximately 12” to 36” from the front panel.
DIMMER Selector Set To
“OFF/WAVE”
Wave Your Hand To Restore The Display
For 10 Seconds
®
®
CKS3088_072106.p65 21/7/2006, 15:04 19