Emerson Radio CKS3088 - Manual (Page 23)

2 2
3.) Lightly touch the LAMP CONTROL Pad on the top panel of the radio to begin
dimming the lamp. Each time you touch the LAMP CONTROL Pad the
brightness will be reduced by approximately 25% until the lamp goes ‘Off’
completely.
Once the lamp is ‘Off’ you can continue touching the LAMP CONTROL Pad to
turn the lamp ‘On’ again and increase it to full brightness. You may leave the
lamp at any of the 4 brightness levels.
IMPORTANT! Remember that you must switch your lamp ‘On’ to its
maximum brightness as usual in order for the LAMP CONTROL Pad to
operate. Touching the LAMP CONTROL Pad has no effect if the lamp is
switched 'Off'.
4.) If you continue to keep your finger on the LAMP CONTROL Pad the brightness
will continue to increase and decrease until you remove your finger from the
control pad.
CKS3088_072106.p65 21/7/2006, 15:04 22