EnGenius Technologies SN-920 - Manual (Page 6)

~ 6~
7. Volume key
(not shown)
17. Status LED
Located on side of handset: up / down buttons control volume.
Blinking: Stand by
Solid: O n a call or the first 8 seconds after power on
8. 2-WAY/INTERCOM
9. Dialing Keypad
10. Ringer (not shown)
Single Beep
Double Beep
Periodic Short Single Beep
Periodic Long Series of Beeps
Continuous Beep
11. Battery Pack Slot (on back of handset)
12. Headset Adapter Port (on bottom of handset)
13. Left Soft Key
14. Right Soft Key
15. Scrolling Keys
16. END
Used to place an intercom call to another handset or base.
Used for dialing phone numbers and entering alphanumeric
information into Phone Directory.
Emits several sounds to indicate various events or alarms.
Successful operation
Failed operation or invalid key. Also, indicates
power on / off.
(every two seconds):
Low battery warning.
(repeat every 30 seconds):
Indicates a call on-hold.
(2 seconds): Indicates out of range while
in talk mode.
On / O ff for power and to end (hang-up) a call
* Caller ID Log
* Two-digit Number Display
* Line or Base Indicator
* Battery Strength
5. Keypad
6. Talk / Flash
Unread messages: Closed Envelope
Read messages: Open Envelope
No information or no Caller ID Service:
No Envelope is Displayed.
Tracks Caller ID log and Phone
Directory record location.
Indicates the base that is active.
(Example: )
Number of bars is proportional to the
amount of battery time remaining.
Answer incoming phone or two-way
radio (intercom) call. Place an
outgoing phone call.
This button also acts as the flash
button for functions like call waiting
and toggling between calls.
19 button face keypad.
Backlight option can be set to O F F,
ON, or 8 seconds time out.
~ 5~