EnGenius Technologies SN-920 - Manual (Page 39)

When using EnGenius SN-900 Ultra, always follow basic safety
precautions to reduce the risk of injury, fire, and electical shock,
including the following practices:
1. Read and understand all instuctions
2. Avoid using a telephone during thunderstorms.
3. Do not use a telephone in the vicinity of a gas leak.
4. Do not use this product near water, or when you are wet.
5. Unplug this product form any line or power source before
cleaning or if it comes in contact with any liguids.
6. Install this product in a protected location
7. This product should be operated only from the type of power
source indicated on the marking label.
included in the user's
manual and this antenna installation instructructions. ln anddition,
observe all warnings and instructions marked on the product.
There may be a
remote chance of electrical shock from lightning.
Report a suspected gas leak immediately, but use a telephone
away from the area where gas may be leaking. Because this
product is a wireless model, make sure the base is also removed
form the area.
For example, do not use it in a wet basement or shower, or next to a
swimming pool, bathtub, kitchen sink, or laundry tub.
Do not use liquids or aerosol sprays for cleaning. Use only a damp
cloth when cleaning. Do not plug the product back in until it has
dried thoroughly.
where it is not at risk
of falling and no one can trip over and line or power cord. Protect
cords from damage or fraying. Do not place and objects on the
power cord.
lf you are not sure of the type of power supplied to your ho me,
consult your dealer or local Power Company. lf this product has
user replaceable betteries, replace batteries only as described in
your user's manual. Do not burn or puncture batteries because
they contain caustic chemicals.
8. Do not short circuit the battery pack.
9. Do not block slots and openings in the cabinet and the back or
bottom, these are provided for ventilation.
10.Never push objects of and kind into this product through
cabinet slots
11.To reduce the risk of electrical shock, do not disassemble this
product.
12.Do not overload wall outlets and extension cords as this can
result in the risk of fire or electrical shock.
13.Unplug this product from the wall outlet if any of the followin g
situations should occur:
The metal bands on the
battery pack should never come in contact with a conductive
surface at the same time. Also, do not let two battery metal bands
touch each other.
To protect it from
overheating, do not block these openings by placing the product on
the bed, sofa, rug, or other similar surfaces. This product should
never be placed near or over or over a radiator or exceed
environmental specifications listed in the user's manual. In
addition, this pro duct should not be placed in a built-in installation
where proper ventilation is not available.
as they may touch dangerous voltage points or short
out parts that could result in a risk of fire or electrical shock.
lf service or repair work is required, contact EnGenius
Customer Service or email us at
[email protected]. Opening or removing cadinet parts other
than specified access doors may expose you to dangerous voltages
or other risks. Lncorrect reassembling can cause electrical
shock when the appliance is subsequently used.
when the power supply cord or plug is damaged or frayed.
lf liquid has been spilled into the product.
lf
the
the product has been exposed to rain or water.
lf the product does not operate normally by following the operating
instructios. Adjust only those controls that are covered by the
operating instructions.
lf the product has been dropped and the cabinet has been
damaged.
lf the product exhibits a distinct change in performance.
TM
SAVE THESE INSTRUCTIONS