Electrolux Front-Load Gas & Electric Dryer 137382100 A (1106) - Manual (Page 18)

18 Installation Instructions
Performing Installation Cycle
WARNING
FIRE HAZARD
Before operating the dryer, make sure the dryer
area is clear and free of combustible materials,
gasoline, and other fl ammable vapors. Also
see that nothing (such as boxes, clothing, etc.)
obstructs the fl ow of combustion and ventilation air.
NOTE
On gas dryers, before the burner will light, it is
necessary for the gas line to be bled of air. If the
burner does not light within 45 seconds the fi rst
time the dryer is turned on, the safety switch will
shut the burner off. If this happens, press cancel
and wait 5 minutes before making another
attempt to light.
NOTE
Dryer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the dryer
through a drying cycle, press the cancel button to put the unit to sleep and then rewake it immediately to
continue the normal operating mode.
If your dryer has this console: If your dryer has this console:
1
2a 2b
3 4
Empty dryer’s drum and close door. 1.
After you plug in the dryer the fi rst time: wake up the 2.
dryer by pressing any button, rotate cycle knob to
cycle one up from lower right position (1), press the
start button (3) and then the cancel button (4).
Wake up the dryer again by pressing any button, then 3.
immediately and simultaneously press and hold but-
tons 2a and 2b for 5 seconds, or until the LCD display
changes.
The LCD window will display 4. INSTAL CYCLE and show
estimated time of cycle completion. Press the start
button. The Installation Cycle will automatically per-
form various diagnostic routines. At cycle completion,
the LCD window may display
INSTAL PASS!, meaning
your new dryer is properly installed and ready for use.
If it prompts an action such as
SERVICE CORD, NO GAS
or call service 877 435 3287, review the installation
steps and make the necessary corrections before you
attempt to use the dryer.
Your dryer will exit the Installation Cycle and return to 5.
normal operation the next time you wake it up.
Please read the 6. Use & Care Guide and enjoy your new
premium dryer!
After you plug in the dryer the fi rst time: wake up the 1.
dryer by pressing any button and follow the prompts
on the LCD User Interface, including language selec-
tion.
The Installation Cycle will automatically test for correct 2.
cord connection (on electric models), presence of
gas supply (on gas models) and free fl ow of exhaust
vent. At cycle completion, the LCD user interface
may display
INSTAL PASS!, meaning your new dryer is
properly installed and ready for use. If it prompts an
action such as
SERVICE CORD, NO GAS or call service
877 435 3287, review the installation steps and make
the necessary corrections before you attempt to use
the dryer.
Your dryer will exit the Installation Cycle and return to 3.
normal operation the next time you wake it up.
Please read the 4. Use & Care Guide and enjoy your new
premium dryer!
With your dryer in fi nal location, perform an Installation Cycle to assist in proper installation.