Eagle Electronics SEAFINDER 500C - Manual (Page 81)

75
To change Ping Speed:
1. From the Sonar Page, press
MENU |
↓ to
P
ING
S
PEED
| ENT .
2. The Ping Speed Control Bar appears. Press
↑ to increase ping speed;
press
↓ to decrease speed. When it's set at the desired level, press
EXIT .
To adjust Sensitivity:
1. From the Sonar Page, press
MENU | ENT .
2. The Sensitivity Control Bar appears. Press
↓ to decrease sensitivity;
press
↑ to increase sensitivity. When it's set at the desired level, press
EXIT . (When you reach the maximum or minimum limit, a tone sounds.)
To turn off HyperScroll:
1. From the Sonar Page, press
MENU |
↓ to
P
ING
S
PEED
| ENT .
2. The Ping Speed Control Bar appears. Press
↓ to decrease ping speed
to 50 percent. When it's set at the desired level, press EXIT .
When you boost ping speed and switch into HyperScroll, the width of
the FasTrack bar graph display doubles in width at the right side of the
screen. This allows you to better see the virtually instantaneous sonar
returns, just as you would on a flasher sonar unit. For more informa-
tion on FasTrack, see its entry in this section.
Pop-up Help
Help is available for virtually all of the menu labels on this unit. By
highlighting a menu item and leaving it highlighted for a few seconds, a
"pop-up" message appears that describes the function of the menu item.
This feature is on by default.
To set up Popup Help: Press MENU | MENU |
↓ to
P OPUP H ELP
. With the
option highlighted, press ENT to check it (turn on) and uncheck it (turn
off). After the option is set, press EXIT to return to the page display.