Eagle Electronics SEAFINDER 500C - Manual (Page 67)

61
If you do experiment with chart speed, remember to reset it to maxi-
mum when you resume trolling or moving across the water at higher
speed. To change chart speed:
1. From the Sonar Page, press MENU |
↓ to
C HART S PEED
| ENT .
2. The Chart Speed Control Bar appears. Press
↓ to decrease chart
speed; press
↑ to increase chart speed.
3. When it's set at the desired level, press EXIT .
ColorLine

ColorLine lets you distinguish between strong and weak echoes. It
"paints" a brighter color on targets that are stronger than a preset
value. This allows you to tell the difference between a hard and soft
bottom. For example, a soft, muddy or weedy bottom returns a weaker
signal which is shown with a narrow, colored line (dark blue tinged
with red or a little yellow.) Since fish are among the weakest echoes,
they show up mostly as blue arches. A hard bottom or other relatively
hard target returns a strong signal which causes a wider brightly col-
ored line (reddish yellow to bright yellow.)
If you have two signals of equal size, one with red to yellow color and
the other without, then the target with brighter color (yellow) is the
stronger signal. This helps distinguish weeds from trees on the bottom,
or fish from structure.
ColorLine is adjustable. Experiment with your unit to find the
ColorLine setting that's best for you. To adjust the ColorLine
level:
1. From the Sonar Page, press
MENU |
↓ to
C
OLORLINE
| ENT .
2. The ColorLine Control Bar appears. Press
↓ to decrease ColorLine;
press
↑ to increase Colorline.
3. When it's set at the desired level, press EXIT .