Electrolux 66300KF-an - Manual (Page 23)

23
2. While the control lamp is flashing rapidly, use the or timersetting
sensor panels to set the desired period of time for this cooking zone up un−
til the point where it automatically switches itself off (e.g. 15 minutes).
The safety cut−out function will be activated after several minutes.
The control lamp will now flash more slowly and the remaining cooking
time will be shown in the display as it elapses. If the safety cut−out func−
tion has been set for more than one cooking zone, the time displayed will
be that for the cooking zone with the shortest period of cooking time re−
maining. The control lamps for the other cooking zones for which the sa−
fety cut−out function has been set will illuminate. To display the remaining
cooking time for any of these cooking zones, it must be selected using the
timer sensor panel, and the corresponding control lamp will then flash ra−
pidly.
To reset the remaining cooking time the desired cooking zone must be se−
lected using the timer sensor panel. The corresponding control lamp will
then flash more rapidly. The settings are reset using the
or timer
setting sensor panels.
After the set period of cooking time has elapsed the cooking zone automa−
tically switches itself off, an acoustic signal sounds for two minutes and the
timer display flashes
.
3. To switch off the signal, touch the timer sensor panel.
To make the setting more quickly, touch any of the or timer setting
sensor panels until the desired value is reached.
If the
timer setting sensor panel is actuated first, the time setting will
begin at 99 minutes, and if the timer setting sensor panel is actuated
first, the time setting will begin at 1 minute.