1 unpacking the module, 2 installing optional flash upgrade, Unpacking the module -2 – Enterasys Networks 6H308-24 User Manual
Page 28: Installing optional flash upgrade -2, Table, Contents of module carton -2, Section 3.1, Section 3.2
Unpacking the Module
3-2
Installation
3.1
UNPACKING THE MODULE
Unpack the module as follows:
1. Open the box and remove the packing material protecting the module.
2. Verify the contents of the carton as listed in
3. Remove the tape seal on the non-conductive bag to remove the module.
4. Perform a visual inspection of the module for any signs of physical damage. Contact Enterasys
Networks if there are any signs of damage. Refer to
for
details.
3.2
INSTALLING OPTIONAL FLASH UPGRADE
If the module is to be installed with an optional FLASH upgrade, refer to
for
installation instructions.
Table 3-1
Contents of Module Carton
Item
Quantity
The 6H308-24 or 6H308-48 Module
1
Antistatic Wrist Strap
1
Manual Accessory Kit
1
NOTE: Install any optional equipment before proceeding to