Enterasys Networks 6H308-24 - Manual (Page 27)

Installation 3-1
3
Installation
This chapter provides the instructions to install the 6H308-24 or 6H308-48. A Phillips screwdriver
is required to install options into the module. Follow the order of the sections listed below to
correctly install the module.
• Unpacking the module ( Section 3.1 )
• Installing Optional FLASH Upgrade ( Section 3.2 )
• Installing the module into the MATRIX E7 Chassis ( Section 3.3 )
• Installing the module into the 6C105 Chassis ( Section 3.4 )
• Connecting to the Network ( Section 3.5 )
• Completing the Installation ( Section 3.6 )
ELECTRICAL HAZARD: Only qualified personnel should install the 6H308-24 or
6H308-48.
NOTE: Read the Release Notes shipped with the module to check for any exceptions to
the supported features and operation documented in this guide.