Enviro WINDSOR 50-1578 - Manual (Page 6)

Installation
R
ATING
L
ABEL
L
OCATION
:
The rating label is located on the back of the hopper.
D
ECIDING
W
HERE TO
L
OCATE YOUR
P
ELLET
A
PPLIANCE
:
1. Check clearances to combustibles (see I
NSTALLATION
- C
LEARANCES TO
C
OMBUSTIBLES
and I
NSTALLATION
- A
LCOVE
C
LEARANCES
).
2. Do not obtain combustion air from an attic, garage or any unventilated space. Combustion air may
be obtained from a ventilated crawlspace.
3. Do not install the stove in a bedroom.
4. You can vent the stove through an exterior wall behind the unit or connect it to an existing masonry
or metal chimney (must be lined if the chimney is over 6” (15 cm) diameter, or over 28 inches² (180
cm²) cross sectional area). An interior vent can be used with approved pipe passing through the
ceiling and roof.
5. Locate the stove in a large and open room that is centrally located in the house. This will optimize
heat circulation.
6. The power cord is 8 feet (2.43 m) long and may require a grounded extension cord to reach the
nearest electrical outlet.
R
EMOVING
P
ELLET
S
TOVE
F
ROM
P
ALLET
:
Figure 1: Removing Freestanding Stove From the Pallet.
Hold-down brackets.
6
Remove screws from the two (2) hold-down
brackets that secure the Windsor to the pallet.
Lift the brackets up to unhook from the chassis.