Electrolux B9879-4 - Manual (Page 54)

54
What to do if
…
If you are unable to remedy the problem by following the above
suggestions, please contact your local Service Force Centre.
Problem Possible cause Remedy
The oven does not heat
up The oven is not switched on Switch the oven on
The clock is not set Set the current time on the
clock
The required settings have
not been set Check the settings
The oven’s safety cut-out has
been tripped See “Safety fuse”
The fuse in the house’s elec-
trical wiring (fuse box) has
been tripped Check fuse. If the fuses trip
repeatedly, please call an au-
thorised electrician
The oven lighting is not
operating The oven bulb is faulty Change the oven bulb
Pyroluxe is not working
C1-REMOVE RUNNERS
appears in the clock dis-
play The oven shelf supports have
not been removed Remove oven shelf support
F11 appears in the clock
display The meat probe has short
circuited or the plug of the
meat probe is not firmly in
position in the socket Insert the plug of the meat
probe as far as it will go into
the socket on the side wall of
the oven
F2 appears in the clock
display Door not properly closed or
door lock defective Close door properly;
Turn the appliance off and
on again via the house fuse
or the safety switch in the
fuse box;
If displayed again, please
contact the Service Force
Centre
An error code not listed
above appears in the
time display Fault in the electronics Switch off the appliance via
the house fuse or the safety
switch in the fuse box and
switch it on again
If displayed again, please
contact your local Service
Force Centre