CHAUVET DJ Swarm 4 FX 3-In-1 LED - Manual (Page 24)

Page 24 of 80 Swarm 4 FX User Manual Rev. 2
Configuration
(Standalone)
Set the product in one of the Standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any Standalone mode (Static, Automatic, or
Sound) to a DMX string connected to a DMX controller. Products in Standalone mode may
transmit DMX signals that could interfere with the DMX signals from the controller.
Sound-Active
Mode
To enable the Sound-Active mode, do the following:
Press repeatedly until Sou- shows on the display.
Press and Sou0 – Sou9 will show on the display.
Use or to select the desired Sound-Active program.
Press .
Turn the music on and adjust the sound sensitivity knob until the product starts responding to
the beat of the music.
The product will only respond to low frequencies of music (bass and drums).
The product will blackout when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.
Automatic Mode To enable the Automatic mode, follow the instructions below:
Press repeatedly until Aut- shows on the display.
Press and Aut0–Aut9 will show on the display.
Use or to select the desired Auto program.
Press and S.01–S.99 will show on the display.
Use or to adjust the program speed.
Press .
Display Timeout To enable or disable the Display Timeout, do the following:
Press repeatedly until SYS shows on the display.
Press and LEdS , tESt , or rESt will show on the display.
Use or to select LEdS .
Press and on or oFF will show on the display.
Use or to select the Display Timeout to be on or oFF .
Press .
Test Mode To run the Swarm 4 FX in Test mode, follow the instructions below:
Press repeatedly until SYS shows on the display.
Press and LEdS , tESt , or rESt will show on the display.
Use or to select tESt .
Press .
Factory Reset To reset the Swarm 4 FX to factory defaults, do the following:
Press repeatedly until SYS shows on the display.
Press and LEdS , tESt , or rESt will show on the display.
Use or to select rESt .
Press .