RME Fireface UCX II 40-Channel USB-B Audio/MIDI Interface User Manual
Page 102

102
User's Guide Fireface UCX II
© RME
Record.
Remain (Rec.).
The medium
’s remaining total record time (limited
by disk space and a maximum of 100 files).
Free.
Free space on the media.
Max R/W Time.
The time needed for the read or write operation.
Details see chapter 38.5.
Playback.
Remain (File).
Remaining play time of the current file.
Next.
Shows and allows to select the next file to be played.
Play Mode.
The following modes are available:
Single:
Stop after playback of the current file
Single next:
Stop after playback of the current file, file selection
jumps to the next file. Start of playback therefore always continu-
ous with the next file.
UFX single:
Plays all consecutive files that belong to one record-
ing session, when these files follow the UFX naming scheme.
Continuous:
Plays all existing files consecutively.
Repeat single:
The current file will be played back in a loop, unlimited.
Repeat all:
Plays all existing files consecutively in a loop. After the last file playback starts again
with the first file.
During playback it is possible to pre-select the next to be played file by navigating to the Next
line and select any of the available files. Single mode is extended by the next file and will stop
after that, unless another file had been selected again.
Continuous
plays all existing files consecutively. Next can still be used to re-play or interactively
change the playlist by selecting any file during playback.
UFX single
plays all files following the incremental UFX name scheme (UFX01_00.wav,
UFX01_01.wav, UFX01_02.wav etc). This feature can be used to build playlists by renaming
other wav files to the same name scheme, then playing them via play mode UFX from a thumb
drive.
Time & Date.
The UCX II has a real-time clock that is set automatically when
connecting the UCX II to a computer with TotalMix FX running.
The clock is used to timestamp the recorded DURec files with the
current time and date values (file attribute). Time & Date can also
be set manually using this easy to use dialog.