Envision Peripherals EN7220 - Manual (Page 8)

EN7220
7
INSTALLATION INSTRUCTIONS
INSTALLING & REMOVING THE BASE
Install Remove
Figure 1 - Installing and Removing the Base
POWERCORD
Power Source:
1. Make sure that the power cord is the correct type required in your area.
2. This LCD monitor has an internal Universal Power Supply that allows
operation in either 100/120V AC or 220/240V AC voltage area (No user
adjustment is required.)
3. Connect the AC-power cord into your LCD monitor’s AC-power-input. The
AC-power cord may be connected to either a wall power outlet or the
power outlet socket on your PC, depending on the type of power cord
supplied with your LCD monitor.
A certified power supply cord has to be used with this equipment. The
relevant national installation and/or equipment regulations shall be
considered. A certified power supply cord not lighter than ordinary polyvinyl
chloride flexible cord according to IEC 60227 (designation H05VV-F 3G
0.75mm
2
or H05VVH2-F2 3G 0.75mm
2
) shall be used. As an alternate, a
flexible cord of synthetic rubber according to IEC 60245 (designation H05RR-
F 3G 0.75mm
2 ) shall be used.
The accessory power cord for the Northern American region is the wall plug
with NEMA 5-15 style and is UL listed and CSA labeled. The voltage rating for
the power cord shall be 125 volts AC.