Envision Peripherals EN7220 - Manual (Page 12)

EN7220
11
INSTALLATION INSTRUCTIONS (cont)
Preparing To Install The Optional Wall Mount Arm (Not
Included)
This monitor can be attached to a wall mounting arm you can purchase
separately. Turn the power OFF then dis-connect the cables from the
monitor before performing the procedure below. Lay the monitor face down
on a soft surface.
1. Remove the two rubber screw covers.
2. Remove the 2 screws that hold the plastic hinge cover.
3. Remove the plastic hinge cover.
4. Remove the small plastic cover. It is attached to the back of the monitor
by hooks.
5. Remove the large plastic cover. It is attached to the back of the monitor
by hooks.
6. Remove the 4 screws holding the stand to the back of the monitor.
7. Remove the stand.