Emerson Radio CKD9907 - Manual (Page 7)

6
OPERATING INSTRUCTIONS
SETTING THE CLOCK
When the unit is first connected to the AC outlet the display will show “12:00” and
will begin counting forward from that point. If no back up battery is installed the
display will revert to this “12:00” default setting every time the AC plug is removed
from the outlet, or whenever the power is interrupted.
To set the display to the correct time:
1. Depress and hold the CLOCK button. The time display begins to flash.
2. While holding the CLOCK button, depress the SKIP + / HOUR button to adjust
the display to the correct hour. Release the button when the correct hour appears.
NOTE: Be sure to set the clock to the correct AM or PM hour by observing the
AM indicator in the upper left corner of the display. If the AM indicator is ‘On’
the time displayed is AM. If the AM indicator is ‘Off’, the time displayed is PM.
3. Depress the CLOCK and SKIP – / MINUTE buttons to adjust the display to the
correct minute, and then release the buttons. The display stops flashing and the
clock begins to run.
Setting The Wake Up Time
The ALARM switch (SET-ON-OFF) is located on the left side of the cabinet.
1. Slide the ALARM switch to the SET position. The clock display changes from
the correct time to the wake up time and begins to flash.
2. Depress the SKIP + / HOUR button to adjust the display to the desired wake up
hour, AM or PM, then release the button.
3. Depress the SKIP – / MINUTE button to adjust the display to the desired wake
up minute, and then release the button.
4. Confirm that the wake up time flashing in the display is correct and then slide
the ALARM switch to either the ON or OFF position.
CKD9907_ib.p65 2001/4/17, PM 12:19 6