Epson 9-Pin Dot Matrix Printer FX-980 - Manual (Page 10)

10
Replacing the Ribbon Cartridge
Remove the separator from the new ribbon
cartridge and discard it. Then turn the
ribbon-tightening knob in the direction of
the arrow to remove any slack in the ribbon. Hold the cartridge with the ribbon-
tightening knob up. Fit the cartridge’s two
front notches (¿) over the small pegs on
each side of the printer as shown. Then lay
the cartridge flat so that the rear notches (¡)
fit over the corresponding pegs.
6
ribbon-tightening knob
separator
7