Panasonic TH-86CQE1W 86" Class 4K UHD Commercial Monitor - Manual (Page 12)

English - 11 -
Connecting the IR Receiver
Before plugging the Display into the mains supply, connect the supplied IR receiver to the IR input on the
Display. Place the IR receiver in sight of your own remote control. Simply operate your remote control whilst
pointed at the IR receiver and it will relay the control signal to your Display.
Note : Do not expose the display to direct sunlight or strong light source during use.
Otherwise the remote control not work or malfunction may occur since the IR reciever of the display uses infrared rays.
Turning the Display On/O ႇ
$IWHUFRQQHFWLQJWKH'LVSOD\WRWKHPDLQVVHWWKHPDLQ2Q2ႇVZLWFKWRWKH³´SRVLWLRQ7KH'LVSOD\ZLOOVZLWFK
into standby mode. Press the Standby button on the remote or press the centre of the joystick in located on
the rear left side of the Display and hold it down for a few seconds to switch it on from standby.
Press the centre of the joystick in and hold it down for a few seconds or press the Standby button on the remote
WRVZLWFKWKH'LVSOD\LQWRVWDQGE\PRGH7RVZLWFKWKH'LVSOD\RႇVHWWKH2Q2ႇVZLWFKWRWKH³´SRVLWLRQ
2
3
98”/86” 75” / 65” / 55”
49” / 43”
3
Standby button
Joystick
2Q2ႇ6ZLWFK (*)
(*) 7KHORFDWLRQRIWKH2Q2௺VZLWFKPD\GL௺HUGHSHQGLQJRQWKHPRGHO
LED Status Status of the display
Power LED lit Green Power on
Power LED lit Red 3RZHURႇ6WDQGE\PRGH
Power LED Red&Green (slow) Starting Up
Power LED Red&Green (fast) Software update
5HDU9ඈHZ
5HDU9ඈHZ