DJI Action 2 Front Touchscreen Module - Manual (Page 14)

DJI Action 2 User Manual
© 2021 DJI OSMO All Rights Reserved. 11
Blinking Pattern Description
Solid green Ready to use
Off
No microSD card detected or insufficient microSD card
storage
Temporarily off While taking photo
Blinks red once every second
While taking video, loop recording*, slow motion,
timelapse, hyperlapse, or QuickClip
During countdown:
10 to 4 s: blinks red once every second
3 to 2 s: blinks red twice every second
1 to 0 s: solid red
After countdown: temporarily off
Countdown to take photo
Blinks red three times Camera powering off
Blinks red and green alternately Updating firmware
Status LED Descriptions
If the front touchscreen module or the power module is connected to the camera unit, their status
LED blinking pattern descriptions will be the same as the camera unit. The status LED blinking pattern
descriptions is as below.
Swipe Left or Right
Swipe left or right on the center of the touchscreen to switch between Photo, Video, QuickClip, Slow
Motion, and Timelapse shooting modes.
Storing Photos and Videos
The camera unit has a built-in storage capacity of 32 GB, which can be used to directly store photos
and videos. Footage shot on DJI Action 2 can be stored on a microSD card (not included) when
connected to the front touchscreen module or power module. A UHS-I Speed Grade 3 rating microSD
card is required due to the fast read and write speeds necessary for high-resolution video data. Insert
the microSD card into the microSD card slot as shown.
DJI Action 2 only supports the exFAT file system. FAT32 is not supported.
* Coming soon.