TOA Electronics U-13R - Unbalanced Line Input Module with High/Low Cut Filters and Mute-Receive for 900 Series (Dual RCA) - Manual (Page 34)

JUMPER SETTINGS
Function Model Jumper Jumper Details
Mute-Receive M-11, T-12, U-11, J5 J6
U-12, U-13, U-14R ON ON Responds to both Mute Bus #1 and Mute Bus #2
activation.
CUT ON Responds to Mute Bus #1 activation only
ON CUT Responds to Mute Bus #2 activation only
CUT CUT No mute function
B-11, L-11 D3 D4
ON ON Responds to both Mute bus #1 and Mute bus #2
activation.
CUT ON Responds to Mute Bus #1 activation only
ON CUT Responds to Mute Bus #2 activation only
CUT CUT No muting
M-11S Mute Response Mode M-11 J3 J4 (Normally-On or Normally-Off)
ON ON No output signal - cut J3 or J4.
CUT ON Normally "OFF" turns "ON" during mute bus activation
ON CUT Normally "ON" turns "OFF" during mute bus activation
CUT CUT No muting function.
Mute-Send S-20S SJP2 Enables Mute Send (VOX)
M-41, U-43 J5 J6
ON ON Activates both Mute Bus #1 and Mute Bus #2
CUT ON Activates only Mute Bus #1
ON CUT Activates only Mute Bus #2
CUT CUT No mute activation.
B-41, L-41 D3 D4
ON ON Activates both Mute Bus #1 and Mute Bus #2
CUT ON Activates only Mute Bus #1
ON CUT Activates only Mute Bus #2
CUT CUT No mute activation.
Phantom Power M-01, M-11, M-21, J1
M-41, M-51, M-61 CUT Disables phantom power.
Master Compressor U-61 J2
CUT Configures module as a Master Compressor
(see page 23).
Remote Master Volume U-21 CUT Configures module as a Remote Master Volume control
(see page 21).
Input Impedance Conversion L-01, L-11, L-41 R1
(600
Ω
to 10 k
Ω
) CUT Changes input impedance from 600
Ω
to 10 k
Ω
allowing maximum voltage transfer (see page 16).
Hysteresis ML-11T SJP101
CUT Disables Mute Send hysteresis
Mute Send (VOX) SJP102
ON Enables VOX function
OFF Disables VOX function
Mute Bus #1 SJP103
Receive Responds to Mute Bus #1 activation only
Send Activates only Mute Bus #1
N/A Disconnects from Mute Bus #1
Mute Bus #2 SJP104
Receive Responds to Mute Bus #2 activation only
Send Activates only Mute Bus #2
N/A Disconnects from Mute Bus #2
Note:
1. In many applications, NO jumper changes are required. Mute-Receive and Mute-Send modules connect to both Mute Bus #1 and Mute Bus #2
by default.
2. Configure the M-11S Mute Response Mode before use - it will not pass signal out-of-the-box.
JUMPER SETTINGS PAGE 35