FlashForge Adventurer 4 3D Printer (FFF) - Manual (Page 26)

Q19 . How to connect to Polar Cloud?
Pictures can contain up to 10 models, while videos 20 models.
The printer adopts fast-slow loading, make sure there is no remaining filament in the
guide tube.
Q23 . Noise in the gear when loading filaments?
Open Polar Cloud website, and log in account. https://polar3d.com;
Click in Cloud Account on the right top corner, roll down the page to find PIN code;
Open Polar Cloud on the printer, enter account number and PIN code;
Turn on the switch and connect to Polar Cloud.
Set printing parameters in the printer. Note that adjustments might be delayed to
take effect, or improper adjustments will affect printing quality, please set it with
caution.
1.
2.
3.
4.
Q20. How to connect to FlashCloud?
Open FlashCloud website: https://cloud.sz3dp.com/login.html;
Open FlashCloud interface or about on the printer;
Add the printer on FlashCloud website, enter name and registration code of
printer;
Turn on the FlashCloud switch to connect the printer.
1.
2.
3.
4.
Q21. How to use camera?
Turn on camera to watch live video on the Cloud；
Time-lapse function will take 100 pictures during printing and makes a video.
1.
2.
In expert mode, the distance can be adjusted directly for experienced users. Details
can be found in the calibration instructions for expert mode.
Q24 . What is expert mode in calibration?
Q25 . How to set printing parameters during printing?
Pay attention to the distance when it moves along the side to avoid
hitting the border.
Q22. Operation of movement
When the length is not selected, press the button to start the movement, and
release the button to stop the movement;
When the length is selected, press to start the movement, release will not stop the
movement until the corresponding length is reached.
1.
2.
Note
Note
25