3 settings – FlashForge Adventurer 4 3D Printer (FFF) User Manual
Page 13
The following functions are included in [Settings]: Move, Network, Fan, Language,
Status, Camera, Brightness, Light, FilamentDetect, Buzzer, PrinterName, About,
FactoryReset.
Move：
to move the extruder left or right, (note that the noise is normal if it moves
past the farthest point of the left side), and to move the build plate back and forth,
(note that the noise is normal if it moves past the farthest point of the front side);
Network：
connect device to hot spot/WLAN/Flash Cloud/Polar Cloud；
Fan：
to turn on/off the fan；
Language：
select language；
Status：
including device temperature，X/Y/Z position，etc.
2.3 Settings
12