FlashForge Adventurer 4 3D Printer (FFF) User Manual
Page 16
After installing a new nozzle, please set the compensation value according to the
temperature the replaced nozzle adopts to; the actual deviation range of the extruder:
-10 ~ 30. Click [next] to enter the extruder selection interface. Select the new nozzle to be
installed and the maximum temperature during preheating will be set according to the
selected nozzle. Please ensure that the installed nozzle is the same as the selected
nozzle type, and click [Complete] to return to the maintenance interface.
if a different nozzle is replaced, the default maximum temperature of
preheating will change to the temperature of the replaced nozzle.
2.4.4 ChangeExtruder
In case of errors or unclear operation, please check and operate according to the
maintenance suggestions first.
2.4.5 Maintain
Note
15