9 first time printing instruction, 8 load filaments – Creality Ender-3 S1 FDM 3D Printer User Manual

Page 9

9 First time Printing Instruction

(www.creality.com) or ﬁnd the Creality

software in the memory card and install it.

Creality Slicer

Select Preferences in sequence → Conﬁgure Creality

→ Next → Select corresponding language → Next →

Finish to complete the setting.

In order to complete the loading smoothly, please trim the end of the ﬁlaments to an inclination of 45°.

First pass the ﬁlament through the ﬁlament detector hole, then press the handle of the extruder, and insert the

ﬁlament along the extruder hole until the nozzle position.

Preheat the nozzle. When the temperature reaches the set value, you can see that there are ﬁlaments ﬂowing out of

the nozzle, and the loading is completed.

8 Load Filaments

Replace ﬁlaments：

1. In the case of no printing operation：

Heat the nozzle to above 185℃ to soften the ﬁlaments in the nozzle. Then press the extrusion handle and pull out the ﬁlaments

quickly to avoid getting stuck in the printer’s pipe;

Change the new ﬁlaments to the rack and install that according to step 8.

2. In the case of being printing：

Pause printing ﬁrst. When the printer stops working, press the extrusion handle and pull out the ﬁlaments quickly to

avoid getting stuck in the printer’s pipe;

Replace the new ﬁlaments to the rack. Thread the ﬁlament through the ﬁlament sensor, press the extrusion handle through the

ﬁlament sensor and insert the ﬁlaments from the feed hole of the extruder into the nozzle. Push the ﬁlaments to remove the

residual ﬁlaments and resume printing after cleaning up.