Creality CR-10 SmPro FDM 3D Printer - Manual (Page 30)

18. Printer maintenance 打印机维护
2.Please use clean water to clean the dirt on the flat pallet.
3.The machine will restart after power interruption and pop out
the “resume printing” button. Please clear the redundant
filament between the nozzle and model before resumption to
avoid printing failure.
3.当发生断电后，机器重启开机启动，会弹出断电续打提示框。需
要断电续打前，建议将喷头与模型之间多余溢料清除干净再继续打印，
以免出现打印失败。
2.当平台板脏污需要清洗时，要用清水来清洗。
1.手动将旋钮左右拧到适合松紧度（顺时针调紧，逆时针调松。）
不要调的过紧，以免拉断皮带，导致机器损坏。（如图所示A处）
1. Manually adjust the tightness as needed by turning the knob left
and right (clockwise to tighten and counterclockwise to loosen.)
Avoid over tightening, which may break the belt and cause damage
to the machine. (As shown in A)
A
A
26