Creality CR-10 SmPro FDM 3D Printer - Manual (Page 21)

12. Load Filament 装料
Snip
剪断处
注意
When it reaches the target temperature, insert the filament into the small hole of the Extruder until it reaches the nozzle through the filament
cutting detection module. If the filament flows out from the nozzle, it presents that the filament is properly loaded.
当前温度达到目标温度时，将耗材通过断料检测模块，插入挤出机小孔直至喷嘴位置，看到喷嘴处有耗材流出即表示耗材已经装载完成。
The method of extrusion spring adjustment: turn left to loosen turn right to tighten (as shown in Fig. A)
调节挤出弹簧松紧度方法：箭头往左调松 往右调紧（如图A所示）
17