Creality CR-10 SmPro FDM 3D Printer - Manual (Page 12)

8.Install the touch screen 安装触摸屏
1
2
Caution
● Do not connect or disconnect the cables when the machine is powered on.
● 当机器通电时，请勿连接或断开连接线。
x 1 ｜ Touch screen 触摸屏 3
08
1. Connect the FFC on the base with the touch screen.
1、把底座的排线与触摸屏连接起来
2. Correctly put 3 mounting holes in the back of the touch screen onto
3 studs in the housing, and carefully complete assembly in a direction
as indicated by the arrow. Conduct disassembly as illustrated.
2、将触摸屏背面三个安装孔水平对准机壳上三个螺丝柱，
并按箭头方向轻轻扣压到位。拆卸按图示方向
安装 拆卸
disassembly
Note:
carry out assembly and disassembly of the touch
screen with care, otherwise the stud is easy to break.
注意：触摸屏安装、拆卸不可用力过猛，螺丝柱易断。
mounting
3