Triplett CTX690 Tone and Probe Kit User Manual
Page 11

12 www.triplett.com
UM-CTX690
and start to send a link pulses to connect the port on
a Ethernet/PoE Switch or Hub.
If an Ethernet link is active on the cable, the
probe begins blinking the link indication port of
the Hub or Switch at the far end and Active Link
Green LED will be on simultaneously.
If no active connection was detected, the Active Link LED
will be off.
2. Link Indicator
If an Ethernet link is active on the cable or network
outlet, the Link Green LED will be blinking.
Simultaneously the tester begins blinking with the
link indicator on a port of Hub/Switch at the far end.
This will assist with troubleshooting for
quickly determine whether an unknown
outlet or cable is connected to an active
Hub/Switch.
If an Ethernet line at far end, Hub is active on the
cable the Link LED will be blinking.
If no active connection was detected, the Link LED will be
off.
NOTE: In Hub blink mode, if a cable is connected to remote unit or
connected to a STP cable, this will cause the Link LED blink.
(G) Replacing Tip
1)
Grasp the tip and gently turn it counterclockwise
until it separates form the probe body.
2)
Replace the old tip with a
compatible new tip and reverse
step1. Note: Do not overtighten
the tip.
(H) Power / Battery Low
1)
Both units require one
standard or alkaline