Panasonic RZ-S300W True Wireless In-Ear Headphones (Green) - Manual (Page 22)

Operation
22
Operating with the touch sensors
You can operate the touch sensors on the earphones to change to the Bluetooth
®
pairing mode, or remote
control the Bluetooth
®
device.
• Depending on the Bluetooth
®
device or the app, even if you operate the touch sensors on the earphones, some
functions may not respond or may operate differently from the descriptions below.
∫ List of operations available with the touch sensors
* With both earphone LEDs (L and R) blinking alternately in blue and red
Note
• You can also use just one side of the earphones independently. In this case, it is only possible to perform operations
available on the side you are using.
• A beep sounds to indicate that you have touched to reach either the maximum or minimum volume level.
Function Touch sensor (L) Touch sensor (R)
Listening to music
Playback/pause Touch once
Raise the volume Touch rapidly 3 times –
Lower the volume Touch rapidly 2 times –
Forward a track – Touch rapidly 2 times
Back a track – Touch rapidly 3 times
Making a phone call
Receive a phone call Touch once while receiving the call
Reject a phone call Touch and hold for about 2 seconds while receiving the call
End a phone call Touch and hold for about 2 seconds during the call
Change control of external
sounds
–
Touch and hold for about
2 seconds
Start the voice assistant Touch and hold for about
2 seconds
–
Set to the Bluetooth
®
pairing
mode
*
( l 16, “Connecting a Bluetooth
®
device”)
Return to the factory settings ( l 23, “Restoring to the factory settings”)