Westcott FJ200 Strobe - Manual (Page 15)

Enabling ‘Freeze Sync’
Ideal for freezing fast-moving objects lit by the strobe. ​ [Available in Manual mode Only.]
1. Quick press the center ​ Control Dial ​ once to enter the Settings menu.
2. Rotate the ​ Control Dial ​ until ​ SYNC ​ is selected with the thin box.
3. Once selected, quickly press the ​ Control Knob ​ until the thin white box turns blue.
4. Rotate the ​ Control Dial ​ until ​ FRE ​ sync is selected.
5. Engage ​ FRE ​ sync by quickly pressing the ​ Control Dial ​ or by pressing the ​ Return | Model ​ button
once.
6. Rotate the ​ Control Dial ​ to make further changes in the ​ Settings ​ menu or press the ​ Return |
Model ​ again to return to the main control screen.
Freeze Sync Flash Durations
● Flash Duration (t0.1)
○ Normal: 1/260~1/2600s
○ Freeze: 1/260~1/7000s
● Flash Duration (t0.5)
○ Normal: 1/800~1/8000s
○ Freeze: 1/800~1/20000s
FJ200 Strobe: Advanced Functions
Continuous Capture
The FJ200’s incredibly fast recycling times allow for rapid burst up to 20fps (frames per second).
NOTE:
1. Available in Manual Mode Only. See section “ ​ Enabling ‘Manual’ Mode Operation ​ ”.
2. 20fps requires Power Output ≤ 4.0 and camera model dependent.
FJ200: Settings Menu
Navigating the Settings Menu
1. Quick press the center ​ Control Dial ​ to enter the ​ Settings ​ menu.
2. Navigate the ​ Settings ​ menu by rotating the ​ Control Dial ​ to move the thin box to the desired
setting.
3. Once the setting is highlighted with the box, quickly press the ​ Control Dial ​ to highlight the
selection in blue and adjust the options for that setting.
4. Rotate the ​ Control Dial ​ to select the desired option.
14