Westcott FJ200 Strobe - Manual (Page 10)

FJ200 Strobe: Getting Started
Charging the FJ200 Lithium Polymer Battery
1. Ensure the FJ200 is ​ OFF ​ by long-pressing the ​ Power | Test ​ button until the LCD screen turns off.
2. Remove the battery from the FJ200 by sliding the release towards the rear of the FJ200 while
gently pulling the battery away from the strobe body.
3. Connect the FJ200 Charger Power Cord to the FJ200 Battery Charger and plug the cord into a
wall outlet. Wait until the AC Power LED indicator light turns red and the four battery LED
indicators to turn green before inserting the battery.
4. Align the gold contacts on the bottom of the FJ200 battery with the pins inside the FJ200
charger, insert the battery into the charger and gently press down until the battery locks into
place.
5. The battery is charged and can be safely removed from the charger when all four battery LED
indicators are full and stopped blinking.
6. Remove the battery from the charger by grasping the sides and gently pulling away from the
charger.
Battery Charger LED Indicator Light Colors
● Solid Red & Solid Green Indicator LEDs
○ No Battery Inserted: ​ ​ The charger is plugged into a power outlet and ready to charge the
FJ200 Li-po Battery.
○ Battery Inserted: ​ The FJ200 Battery is fully-charged and ready to be removed from the
charger.
● Solid Red & Blinking Green Indicator LEDs
○ Battery Inserted: ​ The FJ200 Battery is successfully docked and charging.
Reinserting the FJ200 Lithium Polymer Battery
Reinsert the FJ200 Battery into the strobe by aligning the metal contacts on the bottom of the battery to
the pins inside the battery compartment on the FJ200, slide the battery release on the FJ200 toward the
rear of the unit, and gently press the battery into the battery compartment until it clicks into place.
DC Power Operation
1. Ensure the FJ200 battery has been fully charged.
2. Ensure the battery is securely inserted into the FJ200.
3. Turn the strobe
​ ON ​ by pressing and holding the ​ Power | Test ​ button until the start-up screen
appears. Release the ​ Power | Test ​ button.
AC Power Operation
NOTE: AC operation requires the FJ200 AC Adapter (SKU#4749); sold separately.
9