Epson 31-396 - Manual (Page 14)

14
Fig. 28
12. Assemble appropriate table insert onto the table
using the three screws that were removed in STEP 10.
Fig. 29
Fig. 30
FENCE
If sanding with the belt in the horizontal position, the use
of the fence is recommended.
1. Place the fence (A) on the table as shown in Fig. 29.
2. Align the slots (B) Fig. 29, in the fence with the
tapped holes (C) in the table.
3. Place a 5/16" flat washer (D) Fig. 30, on the fence
knob (E).
4. Insert knob through slot (B) Fig. 30, and thread knob
into tapped hole in table and tighten securely. Repeat
this process for the remaining fence knob.
A
B B
C C
D
E
D
E
B B
O
O
O