Epson LightScene EV-115 2200-Lumen WXGA Laser 3LCD Projector (Black) User Manual
Page 130
130
Depending on the signals from the sensors, you can execute one of the following projector operations
that you have already selected in the projector's menu:
•
Power On
/
Power Off
•
Execute A/V Mute
/
Release A/V Mute
•
Start Playlist
/
Stop Playlist
•
Source Select
•
Light Source Mode: Normal
/
Light Source Mode: Quiet
See the
EV-115/EV-110 External Sensors Setup Guide
for details (only available in English).
Caution:
Incorrect connection could damage the product. Contact a qualified technician to connect the
external sensor device.
Note:
Up to two sensors are available at the same time. You can also select settings for a combination
of two signals. You need to process the sensor cable so that you can connect it to the
DC Out
(2.0A)/GPI In
port. Or, you can use a commercially available connector instead. You can also connect
other external devices such as buttons and switches.
1.
Connect external sensors to the
DC Out (2.0A)/GPI In
port.
2.
Press the
Menu
button on the remote control, select the
Extended
menu, and press
Enter
.
3.
Select
DC Out (2.0A)/GPI In Settings
and press
Enter
.
4.
Select
Always On/On
as the
DC Out/GPI In
setting.
5.
Select
GPI-1 Settings
.
6.
Select the
Low -> High
setting, and then select one of the following operations to be executed when
the sensor signal exceeds a certain voltage:
•
Power On
/
Power Off
to turn the projector on or off.
•
Execute A/V Mute
/
Release A/V Mute
to enable or disable
A/V Mute
.
•
Start Playlist
/
Stop Playlist
to start or stop playing your playlist from
Favorite Playlists
. You also
need to select the target playlist in the
Favorite Playlists
setting.
•
Source Select
to switch the image source. You also need to select the target source in the
Source
setting.
•
Light Source Mode: Normal
/
Light Source Mode: Quiet
to switch the
Light Source Mode
setting.