Sony ICD-UX570 Digital Voice Recorder (Black) - Manual (Page 7)

7
3
Hold down the SET button until the group indication
flashes.
4
Press the + or – button repeatedly to select a group.
5
Press the SET button to enter the group.
The channel indication starts flashing.
6
Press the + or – button repeatedly to select a channel.
7
Press the SET button to enter the channel.
To start signal transmission with the selected channel, turn
off the power and then turn it on again.
To set the group/channel using the pairing
mode of the Cross Remote
When the transmitter is paired with the receiver, the
transmission channel of the transmitter is set to the
receiving channel on the receiver automatically.
For details, see“Pairing with a receiver” on page 7.
Using the Cross Remote
This transmitter is equipped with a wireless remote control
function that can be used to set the parameters (low-cut
filter, attenuation operation, power save mode, etc.) of the
transmitter through the receiver or other devices. This
function makes it easier to operate and manage the
microphone system while in the field.
This wireless control is 2.4-GHz IEEE802.15.4 compliant
and has no effect on the RF band of digital wireless audio.
This function is activated when pairing is established
between the transmitter and the receiver using the RF
REMOTE function.
Pairing must be done first before the wireless remote
control function can be used.
If “RESTRICTED BY GP/CH SETTING” appears on the
RF REMOTE screen, the wireless remote control function
cannot be used. To use the wireless remote control
function, select a different transmission channel.
For details on how to change the transmission channel, see
“Setting the Transmission Channel” on page 6.
Pairing with a receiver
Pairing links the transmitter with the receiver for which the
wireless remote control function is to be used.
When the transmitter has been paired with a receiver
through the receiver operation, turning on the transmitter
while holding down the – button establishes the pairing
immediately.
To carry out pairing through menu operations on the
transmitter, do the following.
1
Set the receiver to be used for controlling the
transmitter to pairing mode.
For details, refer to the operating instructions
supplied with the receiver.
2
Press the + or – button repeatedly until the RF
REMOTE indication is displayed.
3
Hold down the SET button until the item to be set
flashes.
4
Press the + or – button repeatedly to select PAIRING.
5
Press the SET button to enter.
The transmitter sends a pairing request to the receiver
which is on pairing mode.
Before established pairing, if you press any operation
key on the transmitter, pairing mode will be cancelled.
When pairing has been established, the wireless
remote control condition level (indicated by
)
Note
Note