Roborock Q7 Max FCC - Manual (Page 8)

08
When using the robot for the first time, follow
it throughout its whole cleaning route and watch for
potential problems. The robot will be able to clean by
itself in future uses.
Note:
After fixing the charging dock in place, use
a dry cloth to clean the area where the
Moisture-Proof Mat will be located. Tear off
the double-sided tape at the bottom of the
Moisture-Proof Mat, and stick the mat on
the floor, as shown below.
Notes:
• Always place the Moisture-Proof Mat on wooden floors.
• The Moisture-Proof Mat attaches best to smooth surfaces.
• When necessary, remove the double-sided adhesive
tape slowly to reduce residue glue.
B2
Attach the Moisture-Proof Mat
The robot may not turn on when the battery is
low. In this case, place the robot directly onto the dock
to charge.
Note:
Press and hold the button to power on
the robot. When the power light goes on,
place it on the dock to charge. To maintain
the performance of the high-performance
Power On and Charge the Robot
1. Tidy cables and loose items from the
ground and move any unstable, fragile,
precious, or dangerous items to prevent
personal injury or property damage due
to items becoming tangled in, struck by, or
knocked over by the robot.
2. When using the robot in a raised area,
always use a secure physical barrier to
prevent accidental falls that may result in
personal injury or property damage.
B1-1 More than 0.5m (1.6ft)
B1-2 More than 1.5m (4.9ft)
B1
Position the Charging Dock
Keep the charging dock on a level surface,
flat against a wall. Connect the power cable
to the charging dock and tidy cables from
Notes:
• Allow at least 0.5m (1.6ft) of clearance on each side, and
more than 1.5m (4.9ft) in front of the charging dock.
• If the power cable hangs vertical to the ground, it may
be caught by the robot, causing the charging dock to
be disconnected.
• The charging dock indicator is on when the charging
dock is electrified, and off when the robot is charging.
• Do not place the charging dock in places that are
directly exposed to sunlight, or block the location
beacon. Otherwise the robot may not be able to
automatically return to the charging dock.
B3
Mopping
To prevent excessive dirt buildup during first-time
use, floors should be vacuumed at least three times
before mopping.
Note:
Open the upper cover and take out the unit.
B3-1—Remove the dustbin and water tank
combo unit
the floor. To ensure a better user experience
of the mobile app, place the charging dock
in an area with good WiFi coverage.
lithium-ion rechargeable battery pack, keep
the robot charged.
Reinstall the unit. It will click in place.
B3-3—Reinstall the dustbin and water
tank combo unit
Wet the mop cloth and wring it until it stops
dripping, then slide it along the mop cloth
slot before sticking it firmly in place.
B3-4—Install the mop cloth mount
Only use the official Roborock mop cloth. Note:
Notes:
• To prevent corrosion or damage, only use the
Roborock branded floor cleaner in the water tank.
• Do not use hot water as this may cause the tank to deform.
• When filling the water tank, tilt tank 30° to avoid
wetting the filter.
Remove the water tank stopper, fill the tank
with water, and close it tightly.
B3-2—Fill the water tank
Slide the mount forwards along the bottom
of robot until it clicks in place.
B3-5—Install the mop cloth mount