JVC DLA-Z1 - Manual (Page 13)

Main Unit - Input Terminals
.
A B C D E F G
Enlarged View of Rear Face
A [3D SYNCHRO] terminal
By connecting a 3D SYNCHRO EMITTER (sold
separately) to this terminal, you can view 3D movies.
B
[SERVICE] terminal
For updating the software using a commercially
available USB flash drive.
C [RS-232C] terminal (D-sub 9-pin
male)
The projector can be controlled by connecting a PC to
this terminal.
D
[LAN] terminal (RJ-45)
The projector can be controlled by connecting it to a
PC through the computer network for control
commands to be sent to the projector.
E [HDMI 1] input terminal
F
[HDMI 2] input terminal
For connecting to devices that support HDMI output.
(P. 21)
It is fitted to the M3 lock hole. The depth of the screw
hole is 3 mm.
G [TRIGGER] terminal
Output terminal for DC 12 V, 100 mA power supply. It
is used for sending output signals to control devices
such as an elevating screen that is equipped with a
trigger function.
Note that improper connection may damage the
projector. (Tip=DC +12 V, Sleeve=GND)
13
Getting Started