Royal Sovereign RSH 380SL - Manual (Page 13)

12
12. TROUBLESHOOTING
Symptom Cause Possible Solution
Machine will
not turn on:
a. Power switch is in "0" (Off)
position
b. Tripped circuit breaker.
c. Blown main power fuse.
a. Put the power switch to the
"I" (On) position
b. Reset the circuit breaker.
c. Replace the fuse.
There is power, but the
rollers are not turning after the
"RUN" button is
pressed:
a. Safety cover is not closed.
b. Blown motor fuse. a. Close the safety cover to
active the safety switch.
b. Replace the motor fuse.
The unit is not heating up
Call your authorized
dealer
Call your authorized dealer
Curled lamination:
a. Upward curl.
b. Downward curl.
a. Loosen the top roll film tension.
b. Loosen the bottom roll
film tension.
c. Please put the lamination
pass through the DE-CURLING
bar for Single laminating
Unclear lamination:
The main roller temperatures are too
low and/or lamination speed is too fast.
Raise the roller
temperatures and/or
lower the lamination speed.