Royal Sovereign RSH 380SL - Manual (Page 12)

11
Desk Top RSH-SERIES
10. USING CROSS CUTTER
The cross cutter is located on the rear exit table of the machine.
1. After lamination, move the cutter approximately to the center of the completed
application at the desired point of detachment (Figure 1).
2. Grasp film with one hand, press the cutter downward into the application and slide
it first to one end of the application, then to the other end to complete the cut (Figure 2 & 3).
Figure 2 Figure 1 Figure 3
11. MAINTENANCE
Cleaning the Body of the laminator
To clean the machine body, dampen a cloth with water only and gently wipe the machine clean.
Removing Adhesive Build Up
1. Remove the film from the laminator.
2. Use a hard rubber block(crepe rubber or sandpaper belt disc cleaning block)
3. Rub firmly but do not scrub the roller vigorously as this may cause scratch the surface.
4. Do not use any sharp objects, steel, wool or abrasive, as these may damage the rollers
NOTE: Adhesive removes easily when hot. Please use caution when
cleaning hot rollers